Building Instructions

A simple robot for classes, with Vex IQ Touch Sensor.

Remilo comes from esperanto and means paddle.

The robot resembles a boat, but moves on land. It uses two large motors with "paddles" attached to them to move. Because its movement capabilities are limited, it has a gyro sensor to correctly move forward.

Simple mission model, that can be used for competition preparation in class. The model consists of two parts - a stand that can be fixed on a mat, floor or table using a double sided tape and a barbell. The aim is to either take the barbel from the stand and bring it to a target location or the other way round.

Building instructions for the speed bump mission model. The models is used in the Speed bump mission of FLLCasts Off-season Challenge 2019.

Building instructions for the dispenser mission model. The models is used in the Logistics mission of FLLCasts Off-season Challenge 2019.

A 3D scheme on how to connect the front steering motor to the Raspberry PI. This includes the Motor Driver and the batteries. The rear motor is also on this scene. 

Building instructions for the construction plates mission models. The models are used in the Road construction mission of FLLCasts Off-season Challenge with LEGO Mindstorms EV3.

3D scheme on how to connect the L298N Motor Driver to the Batteries. Follow the step-by-step instructions. Be careful about the PCB terminal connectors.

3D scheme with instructions on how to connect the L298N driver to the batteries and to the motor. Just that. Connecting to the Raspberry Pi is at a later stage of the course. 

3D Instructions on how to add a diode to the Raspberry Pi and indicate when the Raspberry Pi is turned on. 

Step by step guide on how to add the SD card to the Raspberry pi. 

The Raspberry Pi must not be powered.  

Shows the pipe attachment constructions that is mounted on the robot. The pipe is than mounted on this constuctions

100x70 cm

These are 3D building instructions on how to connect a diode directly to the batteries and turn it on. 

Use this handout material to learn more about the game and how to play it

Drawing on how to cut a pipe to be able to collect and store balls in this pipe. The sheet format is ISO A4 and the drawing size is real (100% scale)

This is a blueprint of dimensions of the FTC 200 mm axle.