MyBlock that makes a turn on specific degrees with minimal inaccuracy.
Input parameters:
The block that constanlty increase the speed while turning. The goal of this is to reduce the acceleration of the robot when it starts turning so that no modules will fall.
There is only one input parameter in this block and this is the Angle on which you want your robot to rotate.
The program that Nightbeast team use for their second Run in FLL Into Orbit Challange. In this run they Inserts the Tube Module into the Habitation Hub port on the west side, move all four Core Samples so they are no longer touching the axle that held them in the Core Site Model and place the Gas Core Sample completely in Base.
The program that Nightbeast team use for their second Run in FLL Into Orbit Challange. In this run they еject the 2x4 Brick by placing a Regolith Core Sample into the 3D Printer, make the Crater Crossing mission and scores a meteoroid (shoot a ball).
The program that Nightbeast team use for their second Run in FLL Into Orbit Challange. In this run they tries to make missions M10–Food Production, M12–Satellite Orbits and Move the Cone Module to base. But this program should be upgraded.
This is the program for the self aligning passive attachment for rendezvous and meeting between the tube module and the habitation hub. The material is Self Aligning Module Attacher for M06 - Space Station ModulesCreator
This program is for Lifter - an attachment for SUV Box Robot and Into Orbits M09–Strength Exercise material. In this program you may need to change the values in the Wait - Color Sensor blocks if the program is not working properly. The program ses also Gyro sensor, that mean that you have to check do you have a gyro drift. If you have such, turn of the robot and start it again. After turning it on, do not touch the robot until it is completely loaded and ready to run. In that way you are going to cancel the gyro drift.
This Program controls the Module With Aligning Attacher for M08 - Aerobic Exercise. This is a demo program to show how to move robot acurately to the modul. Also how to attach the robot to the modul and acomplish the mission.
The program that Nightbeast team use for their second Run in FLL Into Orbit Challange. In this run they solve Mission 11–Escape Velocity and Mission 13–Observatory.
The program that Nightbeast team use for their first Run in FLL Into Orbit Challange. In this run they solve two missions: SpaceTravel and Solar Panel .
This Program controls the FLL 2018: Attachment To Accomplish The Into Orbit Space Walk Emergency (07) Robot Game Mission. This is a demo program to show how to use this attachment. Also to use this program with 100% succes rate you will have to use starting guider in the base.