This FRIST LEGO League video tutorial is about he Boccia Share mission from FIRST LEGO League 2020 RePlay competition. In the tutorial we demonstrate how to push on a lever to release a mission model part - in this case a box. You have the choice before the competition to cooperate with the other team and to decide if you are going to do the blue or the red box.
10 out of 10 tutorials for the Slide mission was a challenge. There were a lot of glitches with different attachments that we built. At the end we have an attachment that is able to reliably pull the mini figures up, then forward,then down which.
These are construction plates used as Mission Model for preparing for FIRST LEGO League competition off season. They are build with LEGO Mindstorms Robot Inventor set and following the idea of the same places with LEGO Education SPIKE Prime construction plates and LEGO Mindstorms EV3 construction plates
This is a mission model for a drop mission. The mission model is build from LEGO MINDSTORMS Robot Inventor 51515 set. It is large, we know, but again, we wanted to use only parts from the 51515 set.
This program controls a Push/Pull attachment build from a LEGO Mindstorms Robot Inventor 51515 set. Check out the tutorial, building instructions and lesson for this attachment and how the program is used.
This is part one of an FLL 2020 attachment used to accomplish the pull-up bar mission. This is the part of the attachment that stays below the robot. We put the whole robot on this attachment and we move. It is an interesting approach because as we move to the pull up bar this attachment detaches itself from the robot.
In this video tutorial we use an active attachment with a gears, built only form LEGO Mindstorms Robot Inventor parts, to accomplish the FIRST LEGO League 2020 Treadmill mission. The goal of the mission is to rotate the mission model for a couple of seconds so that a pointer makes a half circle rotation. What you will learn is a good principle to approach such missions.